Airworthiness Directive · Amendment 39-19266 · Wings
Airbus Airplanes Republication
Superseded. A later AD replaced this one: AD 2022-06-21. Comply with the one in force.
This AD applies to Airbus Model A318-111, -112, -121, and -122 airplanes; Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320-211, -212, -214, -216, -231, -232, and -233 airplanes; and Model A321-111, -112, -131, -211, -212, -213, -231, and -232 airplanes; certificated in any category; all manufacturer serial numbers, except airplanes specified in paragraphs (c)(1) and (c)(2) of this AD.
(1) Model A318 series airplanes on which Airbus Modification (Mod) 39195 has been embodied in production or Airbus Service Bulletin A320-00-1219 has been embodied in service.
(2) Model A319 series airplanes on which Airbus Mod 28238, Mod 28162, and Mod 28342 have been embodied in production.
We are adopting a new airworthiness directive (AD) for certain Airbus Model A318 series airplanes and Model A319 series airplanes; all Model A320-211, -212, -214, -216, -231, -232, and -233 airplanes; and all Model A321-111, -112, -131, -211, -212, -213, -231, and -232 airplanes. This AD was prompted by an evaluation by the design approval holder (DAH) indicating that the holes of the upper cleat to upper stringer attachments at certain areas of the left- and right-hand wings are subject to widespread fatigue damage (WFD). This AD requires modifying the holes of the upper cleat to upper stringer attachments at certain areas of the left- and right-hand wings. We are issuing this AD to address the unsafe condition on these products.
Before reaching the upper limit, but not before reaching the lower limit, as defined in table 1 to paragraph (g) of this AD, as applicable: Modify the holes of the upper cleat to upper stringer attachments at rib 2 through rib 7 inclusive, on the left- and right-hand wings by oversizing the holes, doing eddy current inspections of the holes for damage, and repairing any damage found before further flight, in accordance with the Accomplishment Instructions of Airbus Service Bulletin A320-57-1208, dated November 21, 2016, except as required by paragraph (h) of this AD; or using a method approved by the Manager, International Section, Transport Standards Branch, FAA; or the European Aviation Safety Agency (EASA); or Airbus's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.
Where Airbus Service Bulletin A320-57-1208, dated November 21, 2016, specifies to contact Airbus for appropriate action, and specifies that action as “RC” (Required for Compliance): Before further flight, accomplish corrective actions in accordance with the procedures specified in paragraph (i)(2) of this AD.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
