19 Airworthiness Directives: 11 airplane, 3 rotorcraft, 4 engine, 1 propeller.
AD 2020-11-11 · published Jun 3, 2020, effective Jun 18, 2020
The Boeing Company Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 777 airplanes. This AD requires a repetitive check of the fuel quantity indicating system (FQIS) fuel quantity calculation for the center wing tank (CWT) fuel quantity, developing a process to provide documentation to the flight crew that this check was done, and revising the existing airplane flight manual (AFM) to incorporate verification procedures and flight crew awareness. This AD was prompted by reports of discrepancies between the FQIS fuel quantity and the refueling truck uploaded fuel amount, followed by certain engine-indicating and crew-alerting system (EICAS) messages. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-11-10 · published Jun 9, 2020, effective Jul 14, 2020
Bombardier, Inc., Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-100-1A10 airplanes. This AD was prompted by a report of an in-flight event where a flightcrew observed a SPOILER FAIL message and had difficulty maintaining roll control of the airplane. This AD requires revising the existing airplane flight manual (AFM) to provide the flightcrew with procedures related to roll spoiler failures that reduce the flightcrew workload during this type of failure scenario. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-11-13 · published Jun 9, 2020, effective Jul 14, 2020
July 14, 2020 Airworthiness Directives; De Havilland Aircraft of Canada Limited (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
The FAA is superseding Airworthiness Directive (AD) 2010-23- 04, which applied to all De Havilland Aircraft of Canada Limited Model DHC-8-400 series airplanes. AD 2010-23-04 required repetitive detailed inspections of the nacelle attachment fittings for cracks, a conductivity inspection of the nacelle attachment fittings, and replacement if necessary. This AD continues to require these inspections and replacement if necessary, removes a certain inspection requirement for certain airplanes, and adds a new requirement to replace the rear spar fitting and nacelle attaching structure with a new nacelle attachment fitting. This AD was prompted by a determination that it is necessary to do a replacement with new nacelle attachment fittings. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-03-50 · published Jun 11, 2020, effective Jun 11, 2020
Cirrus Design Corporation Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Cirrus Design Corporation (Cirrus) Model SF-50 airplanes. This AD was sent previously as an emergency AD to all known U.S. owners and operators of these airplanes. This AD requires disconnecting and removing the headset amplifier and microphone interface circuit card assemblies for the 3.5 mm audio and microphone jacks. This AD was prompted by a cabin fire incident that occurred on a Cirrus Model SF50 airplane during ground operations where the operator observed smoke exiting from behind the right sidewall interior panel. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-12-06 · published Jun 15, 2020, effective Jul 20, 2020
Gulfstream Aerospace Corporation Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Gulfstream Aerospace Corporation (Gulfstream) Model G-IV airplanes. This AD was prompted by reports of un-commanded nose wheel steering turns. This AD requires replacing the nose wheel steering servo valve manifold, incorporating revised operating procedures into the airplane flight manual (AFM), doing a records inspection for any incidents of un-commanded nose wheel steering turns, and reporting the results to the FAA. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-11-14 · published Jun 16, 2020, effective Jul 21, 2020
Bombardier, Inc., Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-100-1A10 airplanes. This AD was prompted by reports of the loss of all air data system information provided to the flightcrew, which was caused by icing at high altitudes. This AD requires revising the existing airplane flight manual (AFM) to provide the flightcrew with procedures to stabilize the airplane's airspeed and attitude. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-12-08 · published Jun 16, 2020, effective Jul 1, 2020
Embraer S.A. (Type Certificate Previously Held by Empresa Brasileira de Aeronáutica S.A.) Airplanes
The FAA is superseding airworthiness directive (AD) 2011-20-01 for certain Empresa Brasileira de Aeron[aacute]utica S.A. (now Embraer S.A.) Model EMB-505 airplanes. AD 2011-20-01 required replacing the bolts that attach the balance mass weights to the elevator structure. This AD requires inspections of the mass-balance weights of the elevators, ailerons, and rudder (flight control surfaces) and their attachment parts and corrective actions if necessary, and revising the airworthiness limitation section of the existing maintenance manual or instructions for continued airworthiness to incorporate new airworthiness limitations. This AD also adds airplanes to the applicability. This AD was prompted by reports of corrosion in the mass-balance weights of the flight control surfaces, and a determination that new airworthiness limitations are necessary. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-11-01 · published Jun 22, 2020, effective Jul 27, 2020
Gulfstream Aerospace Corporation Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Gulfstream Aerospace Corporation (Gulfstream) Model GVI airplanes. This AD was prompted by a report that the primary flight control actuation system (PFCAS) linear variable displacement transducer (LVDT) mechanical disconnect monitor may not trigger the disconnect of the affected control surfaces as required in the event of a control surface failure. This AD requires updating the software of each PFCAS remote electronics unit (REU), which includes an improvement to the LVDT. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-12-10 · published Jun 23, 2020, effective Jul 28, 2020
The Boeing Company Airplanes
The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 747-100, 747-100B, 747-100B SUD, 747-200B, 747-200C, 747-200F, 747-300, 747-400, 747-400D, 747-400F, 747SR, and 747SP series airplanes. This AD was prompted by reports of cracks of the upper splice fittings. This AD requires repetitive detailed inspections and open hole high frequency eddy current (HFEC) inspections of the upper splice fittings for cracks and applicable on- condition actions. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-11-12 · published Jun 25, 2020, effective Jul 30, 2020
The Boeing Company Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 737-8 and 737-9 airplanes. This AD was prompted by a report that certain exterior fairing panels on the top of the engine nacelle and strut (the thumbnail fairing and mid strut fairing panels) may not have the quality of electrical bonding necessary to ensure adequate shielding of the underlying wiring from the electromagnetic effects of high intensity radiated fields (HIRF), which could potentially lead to a dual-engine power loss event and/or display of hazardously misleading primary propulsion parameters. This AD requires a detailed inspection of the thumbnail fairing panels and mid strut fairing panels for excessive rework of the metallic (aluminum foil) inner surface layer, replacement of any excessively reworked panels, and modification of the thumbnail fairing assembly to ensure adequate bonding. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-13-03 · published Jun 25, 2020, effective Jul 15, 2020
XtremeAir GmbH Airplanes
The FAA is superseding Airworthiness Directive (AD) 2018-07-15 for certain XtremeAir GmbH Model XA42 airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as cracking of the diagonal struts of the engine mount frame with potential detachment of the engine from the airplane. The FAA is issuing this AD to require actions to address the unsafe condition on these products.
AD 2020-12-02 · published Jun 8, 2020, effective Jul 13, 2020
Airbus Helicopters
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model EC120B helicopters. This AD was prompted by a report that a changed manufacturing process for the tail rotor blades (TRB) was implemented, affecting the structural characteristics of the blades and generating a new part number for these blades. This AD requires re-identifying each affected TRB having a certain part number and serial number and establishing a life limit for the new part numbers. This AD also prohibits installation of any affected TRB identified with the old part number on any helicopter. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-12-09 · published Jun 23, 2020, effective Jul 28, 2020
Airbus Helicopters
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model EC130B4 and EC130T2 helicopters. This AD was prompted by a report that a changed manufacturing process for the tail rotor blades (TRB) was implemented, affecting the structural characteristics of the blades and generating a new part number for these blades. This AD requires re-identifying each affected TRB having a certain part number and serial number and establishing a life limit for the new part numbers. This AD also prohibits installation of any affected TRB identified with the old part number on any helicopter. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-13-02 · published Jun 23, 2020, effective Jul 8, 2020
Leonardo S.p.A. Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Leonardo S.p.A. Model A119 and AW119 MKII helicopters. This AD requires inspecting for movement and the tightening torque of the tail rotor (T/R) plug, the installation of the outboard and inboard faces of the T/R duplex bearing, and the condition of the T/R plug threads, nut threads, and T/R duplex bearing. Depending on the inspection results, this AD requires removing parts from service, reassembling the T/R duplex assembly, and reporting information. This AD also prohibits installing a T/R duplex bearing unless it has been inspected. This AD was prompted by findings from a preliminary investigation of a Model AW119 MKII helicopter accident. The actions of this AD are intended to address an unsafe condition on these products.
AD 2020-12-03 · published Jun 3, 2020, effective Jun 18, 2020
Rolls-Royce Deutschland Ltd & Co KG (Type Certificate Previously Held by Rolls-Royce plc) Turbofan Engines
The FAA is adopting a new airworthiness directive (AD) for all Rolls-Royce Deutschland Ltd & Co KG Trent XWB-97 model turbofan engines. This AD requires updating electronic engine control (EEC) software. This AD was prompted by the manufacturer's finding that a P30 (air pressure) sense line could become partially blocked with a mixture of ice and water, which would cause a time-lag in the P30 signal, interfering with the fuel flow limit calculations. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-12-01 · published Jun 8, 2020, effective Jul 13, 2020
Rolls-Royce Deutschland Ltd & Co KG (Type Certificate Previously Held by Rolls-Royce plc) Turbofan Engines
The FAA is adopting a new airworthiness directive (AD) for certain Rolls-Royce Deutschland Ltd. & Co KG (RRD) Trent XWB-75, XWB- 79, XWB-79B, and XWB-84 model turbofan engines. This AD was prompted by analysis by the manufacturer of the low-pressure compressor (LPC) outlet guide vane (OGV) assembly and LPC OGV outer mount ring assembly. The analysis predicted that when the front engine mount is in the fail- safe condition, the most highly stressed LPC OGV outer mount ring assembly has a life that could be substantially less than one shop visit interval. This AD requires initial and repetitive inspections of the LPC OGV outer mount ring assembly and, depending on the results of the inspections, possible replacement of the LPC OGV outer mount ring assembly. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-13-04 · published Jun 19, 2020, effective Jul 24, 2020
General Electric Company Turbofan Engines
The FAA is superseding Airworthiness Directive (AD) 2017-09-06 for all General Electric Company (GE) GEnx-1B and GEnx-2B model turbofan engines. AD 2017-09-06 required updating electronic engine control (EEC) full authority digital electronic control (FADEC) software on GEnx-1B and GEnx-2B turbofan engines and replacing a certain fan hub frame assembly part installed on GEnx-2B turbofan engines. This AD requires updating EEC software on GEnx-1B and GEnx-2B engines and replacing a certain fan hub frame assembly part installed on GEnx-2B engines. This AD was prompted by the development of a design change by GE to remove the unsafe condition. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-13-07 · published Jun 26, 2020, effective Jul 13, 2020
Rolls-Royce Deutschland Ltd & Co KG (Type Certificate Previously Held by Rolls-Royce plc) Turbofan Engines
The FAA is adopting a new airworthiness directive (AD) for all Rolls-Royce Deutschland Ltd. & Co KG (RRD) Trent 1000-D2, Trent 1000- J2, and Trent 1000-K2 model turbofan engines with fuel pump, part number G5030FPU01, installed. This AD requires removal and replacement of the fuel pump with a part eligible for installation. This AD was prompted by the manufacturer's investigation into an unexpected reduction in fuel pump performance in certain high life fuel pumps. The FAA is issuing this AD to address the unsafe condition on these products.
AD 2020-12-07 · published Jun 15, 2020, effective Jul 20, 2020
Hamilton Sundstrand Corporation Propellers
The FAA is adopting a new airworthiness directive (AD) for certain Hamilton Sundstrand Corporation (Hamilton Sundstrand) 54H60 model propellers. This AD was prompted by the failure of a propeller blade that resulted in the loss of the airplane. This AD requires initial and repetitive eddy current inspections (ECIs) of the affected propeller blades and replacement of the propeller blades that fail the inspection. The FAA is issuing this AD to address the unsafe condition on these products.
