Cirrus Airworthiness Directives

Name: AerScheduler
Price: 20 USD

Every AD in the library that names a Cirrus aircraft model, gathered from its model pages.

17 not superseded, 3 of them with a repeat action. 19 listed in all, newest published December 6, 2024.

Published sinceHide 2 supersededOnly repeat actions17 of 19

2024-24-11Requires repetitively inspecting (visual) the upper power lever for any crack(s) and depending on the results of any visual inspection, either inspecting (fluorescent penetrant) or replacing the upper power leverPower lever · AirplaneRepeat actionDec 6, 2024
2008-11-18Perform an inspection and replacement as necessary of the heat exchangerCirrus Design Corporation Model SR20 Airplanes · AirplaneRepeat actionJun 2, 2008
2006-21-03Check the maintenance records to determine whether the brake caliper piston O-ring seals were replaced at the last annual or 100-hour inspectionCirrus Design Corporation Models SR20 and SR22 Airplanes · AirplaneRepeat actionOct 13, 2006
2023-09-09Requires repetitively inspecting the spot-welded, multi- segment exhaust tailpipe v-band couplingAerostar Aircraft Corporation, B-N Group Ltd., Commander Aircraft Corporation, Cirrus Design Corporation, Continental Aerospace Technologies Inc., Costruzioni Aeronautiche Tecnam S.P.A., Daher Aerospace, Diamond Aircraft Industries Inc, The Enstrom Helicopter Corporation, Helio Aircraft LLC, Helio Alaska Inc., The King's Engineering Fellowship, Lycoming Engines, Maule Aer · VariousJun 12, 2023
2023-04-20Requires booting the avionics in configuration mode, inhibiting the CAPS autopilot, fabricating and installing information placards, revising the existing airplane flight manual (AFM) for your airplane, and revising...Auto flight system · AirplaneMar 6, 2023
2020-03-50Requires disconnecting and removing the headset amplifier and microphone interface circuit card assemblies for the 3.5 mm audio and microphone jacksCommunications · AirplaneJun 11, 2020
2012-01-11Requires inspection and modification of the air box flange welds and slots and installation of induction system air box seals as applicableEngine air intake · AirplaneJan 25, 2012
2009-26-01Inspect the compression fittings on the anti-ice fluid distribution lines for proper installation and repair any fittings that were not properly installedIce and rain protection · AirplaneDec 14, 2009
2008-14-13Replace the cabin door rod ends with new parts including a redesigned non-binding hinge pin that replaces the existing pin at the upper door hingeCirrus Design Corporation Model SR20 and SR22 Airplanes · AirplaneJul 10, 2008
2008-03-16Inspect the rudder, aileron, and rudder-aileron interconnect rigging; correct any out-of-rig condition; replace the attaching hardware for the rudder-aileron interconnect arm; and report any out-of-rig condition foundCirrus Design Corporation Models SR20 and SR22 Airplanes · AirplaneFeb 5, 2008
2007-24-13Install a drain hole in the left and right outboard wing tipsCirrus Design Corporation Model SR22 Airplanes · AirplaneNov 29, 2007
2007-14-03Replace the pick-up collar support and nylon screws, of the Cirrus Airplane Parachute System (CAPS), with a new design pick-up collar support and custom tension screwsCirrus Design Corporation Models SR20 and SR22 Airplanes · AirplaneJul 12, 2007
2006-19-10Cirrus Design Corporation Models SR20 and SR22 AirplanesAirplaneSupersedes 2005-17-19Sep 19, 2006
2006-07-06Inspect the fuel line and wire bundles for any chafing damage; replace any damaged fuel line and repair any damaged wires or sheathing of the wire harness if any chafing damage is found; and install (to prevent any...Cirrus Design Corporation Models SR20 and SR22 Airplanes · AirplaneMar 30, 2006
2002-24-08Modify the CAPS activation systemCirrus Design Corporation Models SR20 and SR22 Airplanes · AirplaneSupersedes 2002-05-05Dec 10, 2002
2002-21-02Replace the self-locking retaining nut on the roll and yaw trim cartridges with a new self- locking retaining nut with a higher axial load capabilityCirrus Design Corporation Model SR20 and SR22 Airplanes · AirplaneOct 16, 2002
2001-25-03Inspect one time for understrength rivets on the elevator torque tube and rudder hinge and replace any understrength rivetsCirrus Design Corporation Models SR20 and SR22 Airplanes · AirplaneDec 11, 2001

Listed by the model designations in each AD's text. An AD written for a part number, or for "all" engines of a maker, may name no model and so not appear here: search the library for the part or the maker as well.