Airworthiness Directive · Amendment 39-9235 · Turbomeca S.A. Engines
Turbomeca S.A. Engines
Superseded. A later AD replaced this one: AD 2003-16-03. Comply with the one in force.
This AD applies to Turbomeca S.A. Arriel 1A, Arriel 1A1, Arriel 1A2, Arriel 1B, Arriel 1C, Arriel 1C1, Arriel 1C2, Arriel 1D, Arriel 1D1.
The models as the FAA's AD index lists them. The serial ranges, installed parts and exceptions are in the AD itself: read it at the FAA.
This amendment supersedes an existing airworthiness directive (AD), applicable to Turbomeca Arriel 1 series turboshaft engines, that currently requires repetitive checks for engine rubbing noise during gas generator shutdown, and for free rotation of the gas generator by rotating the compressor manually after the last flight of the day. This amendment continues to require these checks, but eliminates the reference to the Turbomeca service bulletin, allows the pilot to perform all the checks required in this AD, clarifies the inspection interval requirement for daily checks, and specifies terminating action for the repetitive checks required by this AD. In addition, this AD allows the check for engine rubbing noise to be performed during engine motoring, and specifies that the engine turbine (T4) temperature must be below 150 degrees Centigrade when performing the check for free rotation. This amendment is prompted by comments submitted by operators of the affected enginesin response to the existing AD and the availability of an improved design 2nd stage nozzle guide vane. The actions specified by this AD are intended to prevent engine failure due to rubbing of the 2nd stage turbine disk on the 2nd stage turbine nozzle guide vane, which could result in complete engine failure and damage to the aircraft.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
