Airworthiness Directive · Amendment 39-23514 · Rotorcraft tail boom
Bell Textron Canada Limited Helicopters
Quoted from the FAA's summary of this AD. The full text below is what applies.
This AD requires the same actions as AD 2022-20-11 and reduces the inspection interval.
Does it apply to your aircraft?
Enter an N-number to see every AD that names its model. Serial numbers and installed parts still decide.
This AD applies to Bell Textron Canada Limited Model 429 helicopters, certificated in any category, as identified in Transport Canada AD CF-2025-60R1, dated January 28, 2026 (Transport Canada AD CF-2025-60R1).
The FAA is superseding Airworthiness Directive (AD) 2022-20- 11, which applied to certain Bell Textron Canada Limited Model 429 helicopters. AD 2022-20-11 required visually inspecting the external surface of the tail rotor (TR) gearbox support assembly, borescope inspecting or visually inspecting the inside of the tail boom, and performing a tactile inspection. Depending on the results of the inspections, AD 2022-20-11 required removing certain rivets from service or repairing gaps in accordance with an approved method. Since the FAA issued AD 2022-20-11, the manufacturer determined the repetitive inspection interval needs to be reduced. This AD requires the same actions as AD 2022-20-11 and reduces the inspection interval. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, Transport Canada AD CF-2025-60R1.
(1) Where Transport Canada AD CF-2025-60R1 refers to its effective date, this AD requires using the effective date of this AD.
(2) Where Transport Canada AD CF-2025-60R1 requires compliance in terms of air time, this AD requires using hours time-in-service.
(3) Where paragraphs (1), (2), and (3) of Part II of Transport Canada AD CF-2025-60R1 specify “since the last inspection in accordance with Part I or Part II of AD CF-2021-15 or Part I of this AD”, for this AD replace that text with “since the last inspection in accordance with Part I of this AD”.
(4) Where the material referenced in Transport Canada AD CF-2025-60R1 specifies “tactile check”, this AD requires replacing that text with “tactile inspection”.
(5) Where the material referenced in Transport Canada AD CF-2025-60R1 specifies to submit a structural repair request, this AD requires repairing any gaps and replacing rivets in accordance with a method approved by the Manager, International Validation Branch, FAA; or Transport Canada; or Bell Textron Canada Limited's Transport Canada Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.
Although the material referenced in Transport Canada AD CF-2025-60R1 specifies to submit certain information to the manufacturer, this AD does not include that requirement.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.