Airworthiness Directive · Amendment 39-23510 · Doors
Airbus Helicopters
Quoted from the FAA's summary of this AD. The full text below is what applies.
This AD requires modifying the swing door star support and sliding door star support stringer.
This AD also prohibits installing an affected composite door on any helicopter unless certain requirements are met.
All Airbus Helicopters (AH) Model EC130B4 helicopters. Serial numbers and exceptions
Does it apply to your aircraft?
Enter an N-number to see every AD that names its model. Serial numbers and installed parts still decide.
This AD applies to all Airbus Helicopters Model EC130B4 helicopters, certificated in any category.
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters (AH) Model EC130B4 helicopters. This AD was prompted by reports of weaknesses in the locking mechanisms on the left-hand side swinging and sliding door. This AD requires modifying the swing door star support and sliding door star support stringer. This AD also prohibits installing an affected composite door on any helicopter unless certain requirements are met. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency AD 2024-0232, dated December 5, 2024 (EASA AD 2024-0232).
(1) Where EASA AD 2024-0232 refers to its effective date, this AD requires using the effective date of this AD.
(2) Where paragraph (1) of EASA AD 2024-0232 specifies to complete the actions within 24 months after its effective date, this AD requires completion within 460 hours time-in-service after the effective date of this AD.
(3) Where the material referenced in EASA AD 2024-0232 specifies performing a dye penetrant inspection, for the purposes of this AD, it is not permitted to use Type 2 colored dye penetrant for inspections required by paragraph (g) of this AD.
(4) Where the material referenced in EASA AD 2024-0232 specifies discarding certain parts, this AD requires removing those parts from service.
(5) Where the material referenced in EASA AD 2024-0232 specifies “check”, this AD requires replacing that text with “inspect”.
(6) This AD does not adopt the “Remarks” section of EASA AD 2024-0232.
Although the material referenced in EASA AD 2024-0232 specifies to submit certain information to the manufacturer, this AD does not require that action.