Airworthiness Directive · Amendment 39-23507 · Wing
The Boeing Company Airplanes
Quoted from the FAA's summary of this AD. The full text below is what applies.
This AD requires a detailed inspection of certain sealant installations in the left, right, and center wing side-of-body areas, an adhesion test of the sealant, and applicable on-condition actions.
Certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. Serial numbers and exceptions
Does it apply to your aircraft?
Enter an N-number to see every AD that names its model. Serial numbers and installed parts still decide.
This AD applies to The Boeing Company Model 787-8, 787-9, and 787-10 airplanes, certificated in any category, as identified in Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025.
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This AD was prompted by a report that, during production, certain sealant installations within the center wing fuel tank did not receive required visual and adhesion inspections. This AD requires a detailed inspection of certain sealant installations in the left, right, and center wing side-of-body areas, an adhesion test of the sealant, and applicable on-condition actions. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified by paragraph (h) of this AD: At the applicable times specified in the “Compliance” paragraph of Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025, do all applicable actions identified in, and in accordance with, the Accomplishment Instructions of Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025.
Note 1 to paragraph (g): Guidance for accomplishing the actions required by this AD can be found in Boeing Alert Service Bulletin B787-81205-SB570053-00, Issue 001, dated November 5, 2025, which is referred to in Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025.
(1) Where the Compliance Time column of the table in the “Compliance” paragraph of Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025, refers to the Issue 001 date of Requirements Bulletin B787-81205-SB570053-00 RB, this AD requires using the effective date of this AD.
(2) Where Boeing Alert Requirements Bulletin B787-81205-SB570053-00 RB, Issue 001, dated November 5, 2025, specifies contacting Boeing for repair instructions, this AD requires doing the repair using a method approved in accordance with the procedures specified in paragraph (i) of this AD. For sealant installation repairs: Complying with Airworthiness Limitations (AWLs) Nos. 28-AWL-83, 28-AWL-120, 28-AWL-121, 28-AWL-123, 28-AWL-124, and 28-AWL-125, as applicable, in Section D, “Summary List of AWLs,” of Boeing 787 Special Compliance Items/Airworthiness Limitations, D011Z009-03-04, dated August 2018, is an acceptable repair.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.