Airworthiness Directive · Amendment 39-23506 · Fuel
The Boeing Company Airplanes
Quoted from the FAA's summary of this AD. The full text below is what applies.
This AD requires repetitive inspections for damage of the transfer pump housing inlet check valves and transfer pump motor impeller inlet adapters for the horizontal stabilizer fuel tank and applicable on-condition actions.
Does it apply to your aircraft?
Enter an N-number to see every AD that names its model. Serial numbers and installed parts still decide.
This AD applies to The Boeing Company Model 747-400 and -8 series airplanes, certificated in any category, as identified in Boeing Alert Requirements Bulletin 747-28A2373 RB, dated November 6, 2025.
The FAA is superseding Airworthiness Directive (AD) 2023-07- 09, which applied to certain The Boeing Company Model 747-400 and -8 series airplanes. AD 2023-07-09 required inspecting for wear of the transfer pump housing inlet check valves and transfer pump motor impeller inlet adapters for the horizontal stabilizer fuel tank and doing corrective actions, if necessary, and limited the installation of affected parts. This AD was prompted by the manufacturer developing further action to address the unsafe condition. This AD requires repetitive inspections for damage of the transfer pump housing inlet check valves and transfer pump motor impeller inlet adapters for the horizontal stabilizer fuel tank and applicable on-condition actions. This AD also limits the installation of affected parts under certain conditions. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified by paragraph (h) of this AD: At the applicable times specified in the “Compliance” paragraph of Boeing Alert Requirements Bulletin 747-28A2373 RB, dated November 6, 2025, do all applicable actions identified in, and in accordance with, the Accomplishment Instructions of Boeing Alert Requirements Bulletin 747-28A2373 RB, dated November 6, 2025.
Note 1 to paragraph (g): Guidance for accomplishing the actions required by this AD can be found in Boeing Alert Service Bulletin 747-28A2373, dated November 6, 2025, which is referred to in Boeing Alert Requirements Bulletin 747-28A2373 RB, dated November 6, 2025.
Where the Compliance Time column of the tables in the “Compliance” paragraph of Boeing Alert Requirements Bulletin 747-28A2373 RB, dated November 6, 2025, refers to the original issue date of Requirements Bulletin 747-28A2373 RB, this AD requires using the effective date of this AD.
As of the effective date of this AD, no person may install, on any airplane, a Crane Aerospace Hydro-Aire horizontal stabilizer fuel transfer pump housing, transfer pump housing inlet check valve, or transfer pump motor impeller into the horizontal stabilizer fuel tank unless the transfer pump housing inlet check valve and transfer pump motor impeller inlet adapter have been inspected as specified in paragraph (g) of this AD, as applicable, and been determined to be a serviceable part as defined in Boeing Alert Requirements Bulletin 747-28A2373 RB, dated November 6, 2025.