Airworthiness Directive · Amendment 39-23504 · Flight controls
Airbus SAS Airplanes
Quoted from the FAA's summary of this AD. The full text below is what applies.
This AD requires the installation of a new FCPC standard and applicable concurrent modifications.
This AD also prohibits the installation of certain parts.
Certain Airbus SAS Model A330-941 airplanes. Serial numbers and exceptions
Does it apply to your aircraft?
Enter an N-number to see every AD that names its model. Serial numbers and installed parts still decide.
This AD applies to Airbus SAS Model A330-941 airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2025-0208, dated September 24, 2025 (EASA AD 2025-0208).
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A330-941 airplanes. This AD was prompted by an occurrence of a triple "PRIM FAULT" in the Flight Control Primary Computer (FCPC) at touchdown. This AD requires the installation of a new FCPC standard and applicable concurrent modifications. This AD also prohibits the installation of certain parts. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2025-0208.
(1) Where EASA AD 2025-0208 refers to its effective date, this AD requires using the effective date of this AD.
(2) This AD does not adopt the “Remarks” section of EASA AD 2025-0208.
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, AIR-520, Continued Operational Safety Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the Continued Operational Safety Branch, send it to the attention of the person identified in paragraph (j) of this AD and email to: AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, AIR-520, Continued Operational Safety Branch, FAA; or EASA; or Airbus SAS's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.
(3) Required for Compliance (RC): Except as required by paragraph (i)(2) of this AD, if any material contains procedures or tests that are identified as RC, those procedures and tests must be done to comply with this AD; any procedures or tests that are not identified as RC are recommended. Those procedures and tests that are not identified as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the procedures and tests identified as RC can be done and the airplane can be put back in an airworthy condition. Any substitutions or changes to procedures or tests identified as RC require approval of an AMOC.
For more information about this AD, contact Frank Carreras, Aviation Safety Engineer, FAA, 2200 South 216th St., Des Moines, WA 98198; phone: 206-231-3539; email: frank.carreras@faa.gov.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
Aircraft