Airworthiness Directive · Amendment 39-23499 · Tail rotor gearbox
Airbus Helicopters
Quoted from the FAA's summary of this AD. The full text below is what applies.
This AD requires repetitive functional inspections (checks) and, depending on the results of the inspections, corrective actions.
All Airbus Helicopters Model SA 365 N helicopters. Serial numbers and exceptions
Does it apply to your aircraft?
Enter an N-number to see every AD that names its model. Serial numbers and installed parts still decide.
This AD applies to all Airbus Helicopters SA 365 N helicopters, certified in any category.
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model SA 365 N helicopters. This AD was prompted by reports of tightening torque loss on the input flange nut due to circular wear on the faces of the flange, the slip ring, and the input flange. This condition, if not addressed, could lead to degradation or jamming of the input roller bearings and loss of yaw control of the helicopter. This AD requires repetitive functional inspections (checks) and, depending on the results of the inspections, corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2026-0029, dated February 12, 2026 (EASA AD 2026-0029).
(1) Where EASA AD 2026-0029 refers to its effective date, this AD requires the effective date of this AD.
(2) Where EASA AD 2026-0029 requires compliance in terms of flight hours, this AD requires using hours time-in-service.
(3) Where EASA AD 2026-0029 or the material referenced in EASA AD 2026-0029 specifies “check”, this AD requires replacing that text with “inspection”.
(4) Where EASA AD 2026-0029 and the material referenced in EASA AD 2026-0029 specify to contact the manufacturer if the comparator gauge confirms a value more than or equal to 0.03 mm, or after completing an oil sample analysis, this AD requires corrective actions in accordance with a method approved by the Manager, International Validation Branch, FAA; EASA; or Airbus Helicopters Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.
Although the material referenced in EASA AD 2026-0029 specifies to submit certain information to the manufacturer, this AD does not require that action.