Airworthiness Directive · Amendment 39-23498 · Cabin equipment/furnishings
Airbus Helicopters Deutschland GmbH (AHD) Helicopters
Quoted from the FAA's summary of this AD. The full text below is what applies.
This AD requires repetitively inspecting the cable drum of certain rescue hoist assemblies for cracks and, depending on the results, replacing or repairing the cable drum of the rescue hoist assembly.
This AD also prohibits the operation and the installation of an affected rescue hoist assembly on a helicopter, unless certain requirements are met.
Certain Airbus Helicopters Deutschland GmbH (AHD) Model EC135P1, EC135P2, EC135P2+, EC135P3, EC135T1, EC135T2, EC135T2+, EC135T3, EC635T2+, MBB-BK 117 C-2, and MBB-BK 117 D-2 helicopters. Serial numbers and exceptions
Does it apply to your aircraft?
Enter an N-number to see every AD that names its model. Serial numbers and installed parts still decide.
This AD applies to Airbus Helicopters Deutschland GmbH (AHD) Model EC135P1, EC135P2, EC135P2+, EC135P3, EC135T1, EC135T2, EC135T2+, EC135T3, and EC635T2+ helicopters, certificated in any category, all serial numbers (S/N) up to 1999; and Model MBB-BK 117 C-2 and MBB-BK 117 D-2 helicopters, certificated in any category, all S/Ns.
Note 1 to paragraph (c): Helicopters with an EC135P3H designation are Model EC135P3 helicopters. Helicopters with an EC135T3H designation are Model EC135T3 helicopters.
Note 2 to paragraph (c): Helicopters with an MBB-BK 117 C-2e designation are Model MBB-BK 117 C-2 helicopters.
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Helicopters Deutschland GmbH (AHD) Model EC135P1, EC135P2, EC135P2+, EC135P3, EC135T1, EC135T2, EC135T2+, EC135T3, EC635T2+, MBB-BK 117 C-2, and MBB-BK 117 D-2 helicopters. This AD was prompted by reports of cracks on the cable drum of the rescue hoist assembly. This AD requires repetitively inspecting the cable drum of certain rescue hoist assemblies for cracks and, depending on the results, replacing or repairing the cable drum of the rescue hoist assembly. This AD also prohibits the operation and the installation of an affected rescue hoist assembly on a helicopter, unless certain requirements are met. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraphs (h) and (i) of this AD: comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2025-0055, dated March 11, 2025 (EASA AD 2025-0055).
(1) Where EASA AD 2025-0055 refers to its effective date, this AD requires using the effective date of this AD.
(2) Where EASA AD 2025-0055 requires compliance in terms of flight hours, this AD requires using hours time-in-service.
(3) Where paragraph (2) of EASA AD 2025-0055 and the material referenced in EASA AD 2025-0055 specifies to contact a manufacturer for repair instructions, for this AD repair an affected rescue hoist assembly in accordance with a method approved by the Manager, International Validation Branch, FAA; EASA; or Airbus Helicopters' Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.
(4) Where the material referenced in EASA AD 2025-0055 specifies “magnifying glass 6X maximum,” this AD requires replacing that text with “4X-6X magnification”.
(5) This AD does not adopt the “Remarks” section of EASA AD 2025-0055.
Although the material referenced in EASA AD 2025-0055 specifies to submit certain information to the manufacturer, this AD does not require that action.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.