Airworthiness Directive · Amendment 39-23042 · Stabilizers
ATR-GIE Avions de Transport Régional Airplanes
This AD applies to ATR—GIE Avions de Transport Régional Model ATR42-500 and ATR72-212A airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2024-0120, dated June 27, 2024 (EASA AD 2024-0120).
The FAA is adopting a new airworthiness directive (AD) for certain ATR--GIE Avions de Transport R[eacute]gional Model ATR42-500 and ATR72-212A airplanes. This AD was prompted by a report of potential use of improper material during the production of vertical tail plane (VTP) fittings. This AD requires, for certain airplanes, an inspection for the material of affected fuselage-to-VTP fittings, an inspection report, and corrective actions, and, for certain other airplanes, part replacement, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2024-0120.
(1) Where EASA AD 2024-0120 refers to its effective date, this AD requires using the effective date of this AD.
(2) This AD does not adopt the “Remarks” section of EASA AD 2024-0120.
(3) Paragraph (5) of EASA AD 2024-0120 specifies to report inspection results to ATR—GIE Avions de Transport Régional within a certain compliance time. For this AD, report inspection results at the applicable time specified in paragraph (h)(3)(i) or (ii) of this AD.
(i) If the inspection was done on or after the effective date of this AD: Submit the report within 30 days after the inspection.
(ii) If the inspection was done before the effective date of this AD: Submit the report within 30 days after the effective date of this AD.
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD and email to: AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or EASA; or ATR—GIE Avions de Transport Régional's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.
For more information about this AD, contact Darren Gassetto, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: 516-228-7323; email: 9-AVS-AIR-BACO-COS@faa.gov.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
