Airworthiness Directive · Amendment 39-22997 · Landing gear
Embraer S.A. (Type Certificate Previously Held by Yaborã Indústria Aeronáutica S.A.; Embraer S.A.) Airplanes
This AD applies to all Embraer S.A. (Type Certificate Previously Held by Yaborã Indústria Aeronáutica S.A.; Embraer S.A.) Model ERJ 190-300 and ERJ 190-400 airplanes, certificated in any category.
The FAA is adopting a new airworthiness directive (AD) for all Embraer S.A. Model ERJ 190-300 and ERJ 190-400 airplanes. This AD was prompted by a report of a MAU 3B failure which led to brake fault advisory messages followed by loss of normal braking that was undetected until the brakes were pressed by the pilots. This AD requires revising the existing airplane flight manual (AFM) to incorporate procedures associated with the failure of certain modular avionics units (MAUs), as specified in an Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, Agência Nacional de Aviação Civil (ANAC) AD 2024-08-01, effective August 19, 2024 (ANAC AD 2024-08-01).
(1) Where ANAC AD 2024-08-01 refers to its “effectivity date,” this AD requires using the effective date of this AD.
(2) This AD does not adopt paragraph (d) of ANAC AD 2024-08-01.
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, AIR-520, Continued Operational Safety Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the Continued Operational Safety Branch, send it to the attention of the person identified in paragraph (j) of this AD and email to: AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, AIR-520, Continued Operational Safety Branch, FAA; or ANAC; or ANAC's authorized Designee. If approved by the ANAC Designee, the approval must include the Designee's authorized signature.
For more information about this AD, contact Krista Greer, Aviation Safety Engineer, FAA, 2200 South 216th St., Des Moines, WA 98198; phone: 206-231-3221; email: krista.greer@faa.gov.
