Airworthiness Directive · Amendment 39-22888 · Equipment/furnishings
Airbus SAS Airplanes
This AD applies to all Airbus SAS Model A321-251NX, -252NX, -253NX, -271NX, and -272NX airplanes, certificated in any category.
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A321-251NX, -252NX, -253NX, -271NX, and -272NX airplanes. This AD was prompted by the discovery during a quality review performed during manufacturing, that a torque strip indicator (material "Dykem") had been applied on the orifice fitting on certain slides' inflation reservoirs' venting holes. This AD requires an inspection for discrepancies of affected parts (certain reservoirs having certain orifices) and replacement of discrepant affected parts, and prohibits installing affected parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2024-0057, dated February 28, 2024 (EASA AD 2024-0057).
(1) Where EASA AD 2024-0057 refers to March 13, 2024, or its effective date, this AD requires using the effective date of this AD.
(2) This AD does not adopt the “Remarks” section of EASA AD 2024-0057.
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the International Validation Branch, mail it to the address identified in paragraph (j) of this AD. Information may be emailed to: AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or EASA; or Airbus SAS's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.
(3) Required for Compliance (RC): Except as required by paragraph (i)(2) of this AD, if any service information referenced in EASA AD 2024-0057 contains paragraphs that are labeled as RC, the instructions in RC paragraphs, including subparagraphs under an RC paragraph, must be done to comply with this AD; any paragraphs, including subparagraphs under those paragraphs, that are not identified as RC are recommended. The instructions in paragraphs, including subparagraphs under those paragraphs, not identified as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the instructions identified as RC can be done and the airplane can be put back in an airworthy condition. Any substitutions or changes to instructions identified as RC require approval of an AMOC.
For more information about this AD, contact Timothy Dowling, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 206-231-3667; email timothy.p.dowling@faa.gov.
