Airworthiness Directive · Amendment 39-22781 · Electrical power
MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
This AD applies to MHI RJ Aviation ULC (Type Certificate previously held by Bombardier, Inc.) Model CL-600-2D15 (Regional Jet Series 705) and Model CL-600-2D24 (Regional Jet Series 900) airplanes, certificated in any category, as identified in Transport Canada AD CF-2023-76, dated November 28, 2023 (Transport Canada AD CF-2023-76).
The FAA is adopting a new airworthiness directive (AD) for certain MHI RJ Aviation ULC Model CL-600-2D15 (Regional Jet Series 705) and CL-600-2D24 (Regional Jet Series 900) airplanes. This AD was prompted by a notice from a supplier reporting that torque wrenches used to install the air driven generator (ADG) downlock cam nut were out of calibration, which resulted in a higher torque level setting than required during the initial production installation of the affected cam nut. This AD requires replacement of the affected ADG locking cam screw and cam nut, as specified in a Transport Canada AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, Transport Canada AD CF-2023-76.
(1) Where Transport Canada AD CF-2023-76 refers to its effective date, this AD requires using the effective date of this AD.
(2) Where Transport Canada AD CF-2023-76 refers to hours air time, this AD requires using flight hours.
(i) Additional AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the International Validation Branch, mail it to the address identified in paragraph (j) of this AD. Information may be emailed to: 9-AVS-NYACO-COS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; Transport Canada; or MHI RJ Aviation ULC's Transport Canada Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.
For more information about this AD, contact Fatin Saumik, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7300; email Fatin.R.Saumik@faa.gov.
