Airworthiness Directive · Amendment 39-22749 · Wing, attach fittings
Piper Aircraft, Inc. Airplanes
This AD applies to Piper Aircraft, Inc. Model PA-28-181, PA-28R-201, PA-34-220T, and PA-44-180 airplanes, certificated in any category, serial numbers as identified in Piper Service Bulletin No. 1413, dated April 9, 2024 (Piper Service Bulletin No. 1413).
The FAA is adopting a new airworthiness directive (AD) for certain Piper Aircraft, Inc. (Piper) Model PA-28-181, PA-28R-201, PA- 34-220T, and PA-44-180 airplanes. This AD was prompted by a report of a double-drilled bolt hole of the rear wing spar attachment fitting found during an unscheduled inspection of an airplane due to a ground collision with an automobile. This AD requires inspecting the rear wing spar attachment fitting and, if discrepancies are found, inspecting the forward wing spar attachment fitting, accomplishing corrective actions as required, and reporting to the FAA when corrective actions are required. The FAA is issuing this AD to address the unsafe condition on these products.
(1) Before further flight after the effective date of this AD, remove the wing fastening hardware securing the aft spar attachment and do the inspection and applicable corrective actions in accordance with Part II, paragraphs 2, 3, 4b, 4c, 5, and 6, of the Instructions in Piper Service Bulletin No. 1413, except the corrosion inspection and corrosion corrective actions are not required by this AD.
(2) If, during the inspection specified in Part II, paragraph 3, of the Instructions in Piper Service Bulletin No. 1413, as required by paragraph (g)(1) of this AD, any discrepancy is found, before further flight, do an inspection of the bolt holes common to the forward spar attachment for wear that exceeds the specified limits, and before further flight replace any component that has a bolt hole that exceeds the specified limits, in accordance with Part II, paragraph 7, of the Instructions in Piper Service Bulletin No. 1413.
(3) If it is determined that the corrective actions required by paragraph (g)(1) or the replacement required by paragraph (g)(2) of this AD are necessary, submit a report to the FAA at the address referenced in paragraph (j) of this AD. The report must include the airplane registration and serial number, airplane hours time-in-service, a description of the condition discovered, the wing or wings affected, and a description of the replacement or corrective action performed. Submit the report at the applicable time specified in paragraph (g)(3)(i) or (ii) of this AD.
(i) If the action was done on or after the effective date of this AD, submit the report within 10 days after the action was done.
(ii) If the action was done before the effective date of this AD, submit the report within 10 days after the effective date of this AD.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
Aircraft
