Airworthiness Directive · Amendment 39-22748 · Flight controls
Airbus Canada Limited Partnership (Type Certificate Previously Held by C Series Aircraft Limited Partnership (CSALP); Bombardier, Inc.) Airplanes
This AD applies to all Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500-1A11 airplanes, certified in any category.
The FAA is adopting a new airworthiness directive (AD) for all Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500-1A11 airplanes. This AD was prompted by the determination that reliance on design assurance level (DAL) D software for flight-critical fly-by-wire (FBW) rigging functions may result in undetected inaccurate positioning of the primary flight control surfaces. This AD requires the use of specific issues of the aircraft maintenance publication (AMP) for electrical rigging procedures, and an electrical rigging confirmation check of primary flight control surfaces for certain airplanes, as specified in a Transport Canada AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, Transport Canada AD CF-2023-15, dated March 2, 2023 (Transport Canada AD CF-2023-15).
(1) Where Transport Canada AD CF-2023-15 refers to its effective date, this AD requires using the effective date of this AD.
(2) Where Transport Canada AD CF-2023-15 refers to hours air time, this AD requires replacing those words with flight hours.
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the International Validation Branch, send it to the attention of the person identified in paragraph (j)(1) of this AD. Information may be emailed to: 9-AVS-AIR-730-AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or Transport Canada; or Airbus Canada Limited Partnership's Transport Canada Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.
(1) For more information about this AD, contact William Reisenauer, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: 516-228-7300; email: 9-avs-nyaco-cos@faa.gov.
(2) For Airbus Canada Limited Partnership service information identified in this AD that is not incorporated by reference, contact Airbus Canada Limited Partnership, 13100 Henri-Fabre Boulevard, Mirabel, Québec J7N 3C6, Canada; telephone 450-476-7676; email a220_crc@abc.airbus; website a220world.airbus.com.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
