Airworthiness Directive · Amendment 39-22242 · Doors
Airbus SAS Airplanes
This AD applies to Airbus SAS Model A300 F4-605R and F4-622R airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2022-0048, dated March 18, 2022 (EASA AD 2022-0048).
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A300 F4-600R series airplanes. This AD was prompted by a determination that the forward cargo door compartment between certain frame forks is susceptible to widespread fatigue damage (WFD). This AD completes certain mandated programs to support the airplane reaching its limit of validity (LOV) of the engineering data that support the established structural maintenance program. This AD requires modifying the forward cargo compartment between certain frame forks, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2022-0048.
(1) Where the service information referenced in EASA AD 2022-0048 specifies installing a label (placard) having part number (P/N) ABS2127B01 on the forward cargo compartment door, this AD allows installing an equivalent label provided the label contains the same information as the label having P/N ABS2127B01.
(2) The “Remarks” section of EASA AD 2022-0048 does not apply to this AD.
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to: 9-AVS-AIR-730-AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or EASA; or Airbus SAS's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.
For more information about this AD, contact Dan Rodina, Aerospace Engineer, Large Aircraft Section, FAA, International Validation Branch, 2200 South 216th St., Des Moines, WA 98198; telephone 206-231-3225; email dan.rodina@faa.gov.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
