Airworthiness Directive · Amendment 39-21890 · Nacelles/pylons
De Havilland Aircraft of Canada Limited (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
Superseded. A later AD replaced this one: AD 2025-05-06. Comply with the one in force.
This AD applies to De Havilland Aircraft of Canada Limited (type certificate previously held by Bombardier, Inc.) Model DHC-8-400, -401, and -402 airplanes, certificated in any category, serial numbers 4001, 4003 through 4550 inclusive, 4583 through 4585 inclusive, 4587, 4588, and 4590.
The FAA is adopting a new airworthiness directive (AD) for certain De Havilland Aircraft of Canada Limited Model DHC-8-400, -401, and -402 airplanes. This AD was prompted by a report that the epoxy primer on the internal bore of the nacelle and landing gear attachment pins was not applied, and corrosion on the internal bore of the wing rear spar attachment pins was found. This AD requires doing a detailed visual inspection of the nacelle to wing rear spar attachment pins, and the nacelle and landing gear attachment pins, for any corrosion, and doing all applicable corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.
(1) At the applicable compliance times specified in paragraphs (g)(1)(i) through (iii) of this AD: Do a detailed visual inspection of the nacelle to wing rear spar attachment pins, and the nacelle and landing gear attachment pins, for any cracking or corrosion, and do all applicable corrective actions, in accordance with Part A or Part B, as applicable, of Section 3., “Accomplishment Instructions,” of the applicable service information specified in figure 1 to paragraph (g) of this AD. Do all applicable corrective actions before further flight.
(i) For nacelle to wing rear spar attachment pins, or nacelle and landing gear attachment pins, as applicable, that have accumulated less than 26,000 flight cycles as of the effective date of this AD, and have been in service less than 12 years from their entry-into-service as of the effective date of this AD: Prior to the pins reaching 14 years from their entry-into-service, or prior to the airplane reaching 30,000 total flight cycles, whichever occurs first.
(ii) For nacelle to wing rear spar attachment pins, or nacelle and landing gear attachment pins, as applicable, that have accumulated 26,000 flight cycles or more as of the effective date of this AD, or have been in service 12 years or more from their entry-into-service as of the effective date of this AD: Within 4 years or 8,000 flight hours after the effective date of this AD, whichever occurs first.
(iii) For airplanes on which the actions specified in Bombardier Service Bulletin 84-54-27, dated August 11, 2017; or Bombardier Service Bulletin 84-54-28, dated August 11, 2017; as applicable, have been accomplished: Within 14 years or 30,000 flight cycles after the date of incorporation of Bombardier Service Bulletin 84-54-27, dated August 11, 2017; or Bombardier Service Bulletin 84-54-28, dated August 11, 2017; as applicable, whichever occurs first.
(2) For serial numbers 4583, 4584, 4585, 4587, 4588 and 4590: At the applicable compliance times specified in paragraphs (g)(1)(i) through (iii) of this AD, re-part mark the yoke attachment pin, in accordance with Part B of the Accomplishment Instructions of De Havilland Aircraft of Canada Limited Service Bulletin 84-54-31, Revision C, dated March 15, 2021.
