Airworthiness Directive · Amendment 39-21805 · Lights
Saab AB, Support and Services (Formerly Known as Saab AB, Saab Aeronautics) Airplanes
This AD applies to Saab AB, Support and Services (Formerly Known as Saab AB, Saab Aeronautics) Model SAAB 340B airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2021-0058, dated March 1, 2021 (EASA AD 2021-0058).
The FAA is adopting a new airworthiness directive (AD) for certain Saab AB, Support and Services Model SAAB 340B airplanes. This AD was prompted by a report that the circuit breaker for the emergency cabin lighting tripped without fault in the system. This AD requires replacing a certain circuit breaker with a part having a higher rating, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2021-0058.
(1) Where EASA AD 2021-0058 refers to its effective date, this AD requires using the effective date of this AD.
(2) The “Remarks” section of EASA AD 2021-0058 does not apply to this AD.
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, Large Aircraft Section, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the Large Aircraft Section, International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to: 9-AVS-AIR-730-AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, Large Aircraft Section, International Validation Branch, FAA; or EASA; or Saab AB, Support and Services' EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
Aircraft
