Airworthiness Directive · Amendment 39-21408 · Stabilizers
Airbus SAS Airplanes
This AD applies to all Airbus SAS airplanes, certificated in any category, as identified in paragraphs (c)(1) through (4) of this AD.
(1) Model A318-111, -112, -121, and -122 airplanes.
(2) Model A319-111, -112, -113, -114, -115, -131, -132, -133, -151N, -153N, and -171N airplanes.
(3) Model A320-211, -212, -214, -216, -231, -232, -233, -251N, -252N, -253N, -271N, -272N and -273N airplanes.
(4) Model A321-111, -112, -131, -211, -212, -213, -231, -232, -251N, -252N, -253N, -271N, -272N, -251NX, -252NX, -253NX, -271NX, and -272NX airplanes.
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A318, A319, A320, and A321 series airplanes. This AD was prompted by a report that following accomplishment of tap tests on certain modified rudders, disbonding of the rudder was found close to the lightning protection plate. This AD requires inspections of the left- and right-hand rudder side shells for defects, and applicable corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2021-0002, dated January 6, 2021 (EASA AD 2021-0002).
(1) Where EASA AD 2021-0002 refers to its effective date, this AD requires using the effective date of this AD.
(2) Where EASA AD 2021-0002 specifies to comply with “the instructions of the AOT,” this AD requires using the words “the procedures marked as required for compliance (RC) in the AOT.”
(3) The “Remarks” section of EASA AD 2021-0002 does not apply to this AD.
Although the service information referenced in EASA AD 2021-0002 specifies to submit certain information to the manufacturer, this AD does not include that requirement.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
