Airworthiness Directive · Amendment 39-19868 · Wings
Airbus SAS Airplanes
This AD applies to Airbus SAS Model A350-941 and -1041 airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2019-0265, dated October 25, 2019 (“EASA AD 2019-0265”).
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by a report of incorrectly engaged lock washer tabs of the main landing gear (MLG) forward pintle bearing (FPB) at the forward face of the trunnion block. This AD requires detailed inspections of the left-hand (LH) and right-hand (RH) side MLG FPB nuts and lock washer tabs, and depending on findings, accomplishment of repetitive detailed inspections or corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2019-0265.
(1) Where EASA AD 2019-0265 refers to its effective date, this AD requires using the effective date of this AD.
(2) The “Remarks” section of EASA AD 2019-0265 does not apply to this AD.
Although the service information referenced in EASA AD 2019-0265 specifies to submit certain information to the manufacturer, this AD does not include that requirement.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
Aircraft
