Airworthiness Directive · Amendment 39-19612 · Time limits and maintenance checks
Dassault Aviation Airplanes
This AD applies to Dassault Aviation Model FAN JET FALCON and FAN JET FALCON SERIES C, D, E, F, and G airplanes, certificated in any category, all serial numbers, except those on which the Dassault Fan Jet Falcon Supplemental Structural Inspection Program (Service Bulletin (SB) 730) has been embodied into the airplane's maintenance or inspection program.
We are adopting a new airworthiness directive (AD) for certain Dassault Aviation Model FAN JET FALCON and FAN JET FALCON SERIES C, D, E, F, and G airplanes. This AD was prompted by a determination of the need for a revision to the airplane airworthiness limitations to introduce changes to the maintenance requirements and airworthiness limitations. This AD requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations and maintenance requirements. We are issuing this AD to address the unsafe condition on these products.
Within 12 months after the effective date of this AD, revise the existing maintenance or inspection program, as applicable, to incorporate the airworthiness limitations and maintenance requirements specified in Chapter 5-40, Airworthiness Limitations, DGT 131028, Revision 17, dated September 2017, of the Dassault Aviation Falcon 20 Maintenance Manual (MM). The initial compliance time for accomplishing the actions is at the applicable time specified in Chapter 5-40, Airworthiness Limitations, DGT 131028, Revision 17, dated September 2017, of the Dassault Aviation Falcon 20 MM; or within 12 months after the effective date of this AD; whichever occurs later. Where the threshold column in the table in paragraph B, Mandatory Maintenance Operations, of Chapter 5-40, Airworthiness Limitations, DGT 131028, Revision 17, dated September 2017, of the Dassault Aviation Falcon 20 MM specifies a compliance time in years, those compliance times are since the date of issuance of the original French or European Aviation Safety Agency (EASA) airworthiness certificate or date of issuance of the original French or EASA export certificate of airworthiness.
After accomplishing the revision required by paragraph (g) of this AD, no alternative actions (e.g., inspections) or intervals may be used unless the actions and intervals are approved as an alternative method of compliance (AMOC) in accordance with the procedures specified in paragraph (j)(1) of this AD.
Accomplishing the actions required by paragraph (g) of this AD terminates all of the requirements of AD 2014-26-07.
