Airworthiness Directive · Amendment 39-19607 · Equipment/furnishings
Airbus SAS Airplanes
Superseded. A later AD replaced this one: AD 2019-17-04. Comply with the one in force.
This AD applies to Airbus SAS Model A350-941 airplanes, certificated in any category, as identified in European Aviation Safety Agency (EASA) AD 2018-0271, dated December 12, 2018 (“EASA AD 2018-0271”).
We are adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 airplanes. This AD was prompted by reports that baby bassinet inserts installed on airplane stowages and partitions were found loose because a self-securing fixation device (Loctite) had not been applied. This AD requires repetitive tightness checks of the baby bassinet inserts installed on stowages and partitions and, depending on findings, accomplishment of applicable corrective actions, as specified in an European Aviation Safety Agency (EASA) AD, which is incorporated by reference. We are issuing this AD to address the unsafe condition on these products.
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2018-0271.
(1) For purposes of determining compliance with the requirements of this AD: Where EASA AD 2018-0271 refers to its effective date, this AD requires using the effective date of this AD.
(2) The “Remarks” section of EASA AD 2018-0271 does not apply to this AD.
Although the service information referenced in EASA AD 2018-0271 specifies to submit certain information to the manufacturer, this AD does not include that requirement.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
Aircraft
