Airworthiness Directive · Amendment 39-19599 · Turbine section
International Aero Engines Turbofan Engines
This AD applies to International Aero Engines (IAE) PW1133G-JM, PW1133GA-JM, PW1130G-JM, PW1127G-JM, PW1127GA-JM, PW1127G1-JM, PW1124G-JM, PW1124G1-JM, and PW1122G-JM turbofan engines with a low-pressure turbine (LPT) 3rd-stage disk with a serial number (S/N) listed in Figure 1 to paragraph (g) of this AD or an LPT 1st-stage disk with an S/N listed in Figure 2 to paragraph (g) of this AD, installed.
We are superseding Airworthiness Directive (AD) 2018-24-01 for certain International Aero Engines (IAE) PW1133G-JM, PW1133GA-JM, PW1130G-JM, PW1127G-JM, PW1127GA-JM, PW1127G1-JM, PW1124G-JM, PW1124G1- JM, and PW1122G-JM turbofan engines. AD 2018-24-01 required removing certain low-pressure turbine (LPT) 1st- and 3rd-stage disks from service and replacing with a part eligible for installation. This AD retains the same requirements as AD 2018-24-01. This AD was prompted by the discovery of incorrect serial numbers in the identification of LPT disks in AD 2018-24-01. We are issuing this AD to address the unsafe condition on these products.
Remove from service the LPT 1st- and 3rd-stage disk within 30 days after the effective date of this AD, or as identified in paragraphs (g)(1) or (2) of this AD, whichever occurs later, and replace with a part eligible for installation.
(1) Remove the LPT 3rd-stage disk with an S/N listed in Figure 1 to paragraph (g) of this AD at the next piece-part exposure, not to exceed 4,800 cycles since new (CSN).
(2) Remove the LPT 1st-stage disk with an S/N listed in Figure 2 to paragraph (g) of this AD at the next piece-part exposure, not to exceed 2,240 CSN.
