Airworthiness Directive · Amendment 39-19034 · Time limits/maintenance checks
Dassault Aviation Airplanes
Superseded. A later AD replaced this one: AD 2019-24-11. Comply with the one in force.
This AD applies to Dassault Aviation Model FALCON 900EX airplanes, certificated in any category, serial numbers 1 through 96 inclusive, and serial numbers 98 through 119 inclusive, certificated in any category.
We are adopting a new airworthiness directive (AD) for certain Dassault Aviation Model FALCON 900EX airplanes. This AD was prompted by a determination that new or more restrictive maintenance requirements and/or airworthiness limitations are necessary. This AD requires revising the maintenance or inspection program, as applicable, to incorporate new or more restrictive maintenance requirements and/or airworthiness limitations. We are issuing this AD to address the unsafe condition on these products.
Within 90 days after the effective date of this AD, revise the maintenance or inspection program, as applicable, to incorporate the information specified in Chapter 5-40, Airworthiness Limitations, Revision 14, dated November 2015, of the FALCON 900EX Maintenance Manual. The initial compliance time for accomplishing the actions specified in Chapter 5-40, Airworthiness Limitations, Revision 14, dated November 2015, of the FALCON 900EX Maintenance Manual, is within the applicable times specified in the maintenance manual, or 90 days after the effective date of this AD, whichever occurs later, except as provided by paragraphs (g)(1) through (g)(4) of this AD.
(1) The term “LDG” in the “First Inspection” column of any table in the service information means total airplane landings.
(2) The term “FH” in the “First Inspection” column of any table in the service information means total flight hours.
(3) The term “FC” in the “First Inspection” column of any table in the service information means total flight cycles.
(4) The term “M” in the “First Inspection” column of any table in the service information means months.
After accomplishing the revision required by paragraph (g) of this AD, no alternative actions (e.g., inspections) or intervals may be used unless the actions or intervals are approved as an alternative method of compliance (AMOC) in accordance with the procedures specified in paragraph (j)(1) of this AD.
Accomplishing the actions required by paragraph (g) of this AD terminates all the requirements of AD 2014-16-26.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
Aircraft
