Airworthiness Directive · Amendment 39-18599 · Fuselage
Airbus Airplanes
Superseded. A later AD replaced this one: AD 2019-08-06. Comply with the one in force.
This AD applies to the Airbus airplanes identified in paragraphs (c)(1), (c)(2), and (c)(3) of this AD, certificated in any category, manufacturer serial numbers 1175, 1180, 1287 through 1475 inclusive, 1478, 1480, 1483, and 1506.
(1) Model A330-223F and -243F airplanes.
(2) Model A330-201, -202, -203, -223, and -243 airplanes.
(3) Model A330-301, -302, -303, -321, -322, -323, -341, -342, and -343 airplanes.
The FAA is correcting an airworthiness directive (AD) that published in the Federal Register. That AD applies to certain Airbus Model A330-200 Freighter, -200, and -300 series airplanes. Paragraphs (i) and (l) of the regulatory text contain typographical errors in the service bulletin number. This document corrects those errors. In all other respects, the original document remains the same.
Within 72 months since first flight of the airplane, do an eddy current inspection (i.e., conductivity measurement) of affected structural parts in the cargo compartment to determine if proper heat treatment has been done as identified in, and in accordance with, the Accomplishment Instructions of Airbus Service Bulletin A330-53-3227, dated August 18, 2015.
If, during the inspection required by paragraph (g) of this AD, an affected structural part in the cargo compartment is identified to have a measured value greater than 26 megasiemens per meter (MS/m), or greater than 44.8% International Annealed Copper Standard (IACS), before further flight, replace the affected structural part with a serviceable part, in accordance with the Accomplishment Instructions of Airbus Service Bulletin A330-53-3227, dated August 18, 2015.
If, during the inspection required by paragraph (g) of this AD, an affected structural part in the cargo compartment is identified to have a measured value other than those specified in Figure A-GFAAA, Sheet 01, “Inspection Flowchart,” of Airbus Service Bulletin A330-53-3227, dated August 18, 2015, before further flight, repair using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA); or Airbus's EASA Design Organization Approval (DOA).
Within 72 months since first flight of the airplane, do an eddy current inspection of affected structural parts in the cabin compartment to determine if proper heat treatment has been done as identified in, and in accordance with, the Accomplishment Instructions of Airbus Service Bulletin A330-53-3228, dated August 18, 2015.
If, during the inspection required by paragraph (j) of this AD, an affected structural part in the cabin compartment is identified to have a measured value greater than 26 MS/m or greater than 44.8% IACS, before further flight, replace the affected structural part with a serviceable part, in accordance with the Accomplishment Instructions of Airbus Service Bulletin A330-53-3228, dated August 18, 2015.
If, during the inspection required by paragraph (j) of this AD, an affected structural part in the cabin compartment is identified to have a measured value other than those specified in Figure A-GFAAA, Sheet 01, “Inspection Flowchart,” of Airbus Service Bulletin A330-53-3228, dated August 18, 2015, before further flight, repair using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the EASA; or Airbus's EASA DOA.
