Airworthiness Directive · Amendment 39-17531 · Fuselage
The Boeing Company Airplanes
This AD applies to The Boeing Company Model 727, 727C, 727-100, 727-100C, 727-200, and 727-200F series airplanes, certificated in any category, as identified in Boeing Special Attention Service Bulletin 727-53-0234, dated January 17, 2013.
We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 727 airplanes. This AD was prompted by an evaluation by the design approval holder indicating that the frame-to- floor beam attachment is subject to widespread fatigue damage. This AD requires repetitive high frequency eddy current inspections for any crack of the frames at body station (STA) 188 through STA 344, and repair if necessary. We are issuing this AD to detect and correct fatigue cracking at the frame-to-floor beam attachment, on both the left- and right-sides, which could result in reduced structural integrity of the airplane, and decompression of the cabin.
Before the accumulation of 61,000 total flight cycles, or within 24 months after the effective date of this AD, whichever occurs later, do a high frequency eddy current inspection for cracking of the frames (for certain stations), in the area of the floor beam attachments on both the left- and right-sides of the airplane, in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 727-53-0234, dated January 17, 2013. Repeat this inspection thereafter at intervals not to exceed 20,000 flight cycles. If any crack is found during any inspection required by this AD, before further flight, repair the crack using a method approved in accordance with the procedures specified in paragraph (h) of this AD.
