Airworthiness Directive · Amendment 39-17262 · Ac generator-alternator
The Boeing Company Airplanes
This AD applies to The Boeing Company Model 777-200, -200LR, -300, -300ER, and 777F series airplanes, certificated in any category, as identified in Boeing Alert Service Bulletin 777-24A0119, dated November 11, 2011.
We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 777 airplanes. This AD was prompted by reports of failure of wire support clamps in the forward section of the aft pressure bulkhead. This AD requires a detailed inspection of the clamps on the power feeder cable of the auxiliary power unit (APU) to determine if certain clamps are installed, and related investigative and corrective actions if necessary. We are issuing this AD to prevent failure of the clamp, which could result in wire chafing and potential arcing and consequent fire in section 48 (a flammable fluid leakage zone) or heat damage to the APU power feeder cable, insulation blankets, or pressure bulkhead.
Within 48 months after the effective date of this AD: Do a detailed inspection of the clamps on the APU power feeder cable to determine if TA027063 clamps are installed, and all applicable related investigative and corrective actions, in accordance with the Accomplishment Instructions of Boeing Alert Service Bulletin 777-24A0119, dated November 11, 2011, except as required by paragraphs (h) and (i) of this AD. Do all related investigative and corrective actions before further flight.
If during any inspection of the fuselage structure required by paragraph (g) of this AD, no primer discoloration or structural deterioration is found, before further flight, repair the APU power feeder cable and insulation blanket and replace the existing clamps, in accordance with steps 3.B.7, 3.B.8, and 3.B.9 of the Accomplishment Instructions of Boeing Alert Service Bulletin 777-24A0119, dated November 11, 2011.
Where Boeing Alert Service Bulletin 777-24A0119, dated November 11, 2011, specifies to do the repair in accordance with the instruction from Boeing, before further flight, repair using a method approved in accordance with the procedures specified in paragraph (j) of this AD.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
Aircraft
