Airworthiness Directive · Amendment 39-16502 · Wings
The Boeing Company Model 757 Airplanes
This AD applies to all The Boeing Company Model 757-200, -200PF, -200CB, and -300 series airplanes, certificated in any category.
We are adopting a new airworthiness directive (AD) for all Model 757 airplanes. This AD requires changing the lower fixed leading edge panel assemblies immediately outboard of the nacelles at slats 4 and 7. This AD results from reports of Model 757 airplanes in service that have drain holes and unsealed panel assemblies in the fixed leading edge adjacent to the inboard end of slats 4 and 7 that are too close to the hot portion of the engines. We are issuing this AD to prevent fuel leaking onto an engine and a consequent fire.
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
Within 60 months after the effective date of this AD, change the lower fixed leading edge panel assemblies immediately outboard of the nacelles at slats 4 and 7, in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 757-57-0070, dated January 27, 2010; except, where the service bulletin specifies washer part number (P/N) NAS11490632J for the modification of the lower fixed leading edge panel assemblies, this AD requires installation of P/N NAS1149D0632J.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
Aircraft
