AD 2010-16-11

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

Before the accumulation of 30,000 total flight hours, or within 15,000 flight hours after the effective date of this AD, whichever occurs later, do a general visual inspection of the retract cylinder support fitting for the MLG and the mating bore in the MLG trunnion fitting for corrosion, install bushings and bearings without cadmium plating in the bore, and do all applicable corrective actions, in accordance with Configuration 1 of the Accomplishment Instructions of Boeing Service Bulletin MD90-57-016, Revision 2, dated April 28, 2006. Do all applicable corrective actions before further flight.

Note 1: For the purposes of this AD, a general visual inspection is: “A visual examination of an interior or exterior area, installation, or assembly to detect obvious damage, failure, or irregularity. This level of inspection is made from within touching distance unless otherwise specified. A mirror may be necessary to ensure visual access to all surfaces in the inspection area. This level of inspection is made under normally available lighting conditions such as daylight, hangar lighting, flashlight, or droplight and may require removal or opening of access panels or doors. Stands, ladders, or platforms may be required to gain proximity to the area being checked.”

(h) Doing a general visual inspection, installing bushings and bearings, and doing all applicable corrective actions is also acceptable for compliance with the requirements of paragraph (g) of this AD if done before the effective date of this AD in accordance with the Accomplishment Instructions of Boeing Service Bulletin MD90-57-016, Revision 1, dated October 26, 2005.

(i) Doing a general visual inspection, installing bushings and bearings, and doing all applicable corrective actions is also acceptable for compliance with the requirements of paragraph (g) of this AD if done before the effective date of this AD in accordance with the Accomplishment Instructions of Boeing Service Bulletin MD90-57-016, dated September 18, 2002, provided that before the accumulation of 30,000 total flight hours, or within 15,000 flight hours after the effective date of this AD, whichever occurs later, electroless nickel fittings are installed, and bushings and bearings without cadmium plating in the bore are installed in accordance with the Accomplishment Instructions of any of the service bulletins listed in Table 1 of this AD.