Airworthiness Directive · Amendment 39-15958 · General Electric Company (GE) CF6-80C2B5F Turbofan Engines
General Electric Company (GE) CF6-80C2B5F Turbofan Engines
This AD applies to General Electric Company (GE) CF6-80C2B5F turbofan engines with a high-pressure compressor rotor (HPCR) stages 11-14 spool/shaft, part number (P/N) 1703M74G03, installed. These engines are installed on, but not limited to, Boeing 747 series airplanes.
The FAA is adopting a new airworthiness directive (AD) for GE CF6-80C2B5F turbofan engines. This AD requires removing certain part number (P/N) high-pressure compressor rotor (HPCR) stages 11-14 spool/ shafts before they exceed a new, reduced life limit. This AD results from an internal GE audit that compared the life limited parts certification documentation to the airworthiness limitations section (ALS) of the instructions for continuing airworthiness (ICA). We are issuing this AD to prevent HPCR stages 11-14 spool/shaft fatigue cracks caused by exceeding the life limit, which could result in a possible uncontained failure of the HPCR spool/shaft and damage to the airplane.
You are responsible for having the actions required by this AD performed within the compliance times specified unless the actions have already been done.
Remove any CF6-80C2B5F turbofan engine that has an HPCR stages 11-14 spool/shaft, P/N 1703M74G03, before the spool/shaft meets or exceeds the new, reduced life cycle limit of 19,500 cycles.
After the effective date of this AD, do not install any CF6-80C2B5F turbofan engine that has an HPCR stages 11-14 spool/shaft, P/N 1703M74G03, that meets or exceeds 19,500 cycles.
