Airworthiness Directive · Amendment 39-15428 · Electrical wiring
Pacific Aerospace Corporation, Ltd Model 750XL Airplanes
This AD applies to Model 750XL airplanes, serial numbers 102 through 134, certificated in any category.
Note 1: The applicability of this AD takes precedence over Pacific Aerospace Corporation Limited Mandatory Service Bulletin PACSB/XL/009, issue 2, revised July 23, 2004.
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Unless already done, do the following actions:
(1) Within the next 100 hours time-in-service (TIS) after April 23, 2008 (the effective date of this AD), inspect the main wiring loom on the right hand side of the aircraft adjacent to the frames at station 114.34” and 118.84” to ensure there are two pieces of protective sleeving installed following Pacific Aerospace Corporation Limited Mandatory Service Bulletin PACSB/XL/009, issue 2, revised July 23, 2004.
(2) If you find the protective sleeves are missing as a result of the inspection required by paragraph (f)(1) of this AD, before further flight, install protective sleeves following Pacific Aerospace Corporation Mandatory Service Bulletin PACSB/XL/009, issue 2, revised July 23, 2004.
Note 2: This AD differs from the MCAI and/or service information as follows: No differences.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
Aircraft
