Airworthiness Directive · Amendment 39-14962 · Construcciones Aeronauticas, S.A., (CASA) Model C-212 Airplanes
Construcciones Aeronauticas, S.A., (CASA) Model C-212 Airplanes
Superseded. A later AD replaced this one: AD 2008-06-13. Comply with the one in force.
This AD applies to Construcciones Aeronauticas, S.A., (CASA) Model C-212 airplanes; all series, all serial numbers; certificated in any category.
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as follows:
Unless already done, do the following actions.
(1) For airplanes used for maritime operations and all other airplanes on which the operator cannot positively determine that the airplanes have not been flown more than ten percent of flights at altitudes below 3,000 feet as of the effective date of this AD: Perform a Non-Destructive Inspection (NDI) and a complementary NDI for cracks at the applicable time specified in paragraph (f)(1)(i), (f)(1)(ii), or (f)(1)(iii) of this AD. Do the inspections as defined in EADS-CASA All Operator Letter 212-018, Revision 1, dated December 1, 2006.
Note: For the purposes of this AD, the term “maritime operations” is defined as airplanes which are used for monitoring certain areas of water.
(i) For airplanes having accumulated 5,600 flight hours or less, and 2,400 landings or less, as of the effective date of this AD: Perform the inspections before the accumulation of 5,600 total flight hours or 2,400 total landings after the effective date of this AD, or within 6 months after the effective date of this AD, whichever occurs latest.
(ii) For airplanes having accumulated more than 5,600 flight hours but less than or equal to 8,000 flight hours, or more than 2,400 landings but less than or equal to 3,600 landings, as of the effective date of this AD: Perform the inspections before the accumulation of 200 flight hours or 100 landings after the effective date of this AD, whichever occurs first.
(iii) For airplanes having accumulated more than 8,000 flight hours or more than 3,600 landings as of the effective date of this AD: Perform the inspections within 14 days after the effective date of this AD.
(2) For airplanes other than those identified in paragraph (f)(1) of this AD: Perform the NDIs at the applicable time specified in paragraph (f)(2)(i), (f)(2)(ii), or (f)(2)(iii) of this AD. Do the inspections as defined in EADS-CASA All Operator Letter 212-018, Revision 1, dated December 1, 2006.
(i) For airplanes having accumulated 10,000 flight hours or less, and 10,000 landings or less as of the effective date of this AD: Perform the inspections before the accumulation of 10,000 total flight hours or 10,000 total landings after the effective date of this AD, or within 6 months after the effective date of this AD, whichever occurs latest.
(ii) For airplanes having accumulated more than 10,000 flight hours but less than or equal to 15,000 flight hours, or more than 10,000 landings but less than or equal to 15,000 landings, as of the effective date of this AD: Perform the inspections before the accumulation of 200 flight hours or 100 landings after the effective date of this AD, whichever occurs first.
(iii) For airplanes having accumulated more than 15,000 flight hours or more than 15,000 landings as of the effective date of this AD: Perform the inspections within 14 days after the effective date of this AD.
(3) No further flight is allowed if any cracks are detected when performing the actions specified in paragraphs (f)(1) and (f)(2) of this AD. Before further flight, repair any cracking found during any inspection required by this AD using a method approved by either the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA) (or its delegated agent). Within 30 days after cracks are detected, or within 30 days after the effective date of this AD, whichever occurs later, send a detailed report of the findings (both positive and negative) of the inspections required by paragraph (f) of this AD to EADS-CASA for evaluation at the following address: EADS-CASA, Military Transport Aircraft Division, Integrated Customer Services, Technical Services, Avenida de Aragon 404, 28022-Madrid, Spain; telephone 34-91-624-6306; fax 34-91-585-5505. E-mail: MTA, TechnicalService@casa.eads.net. In any case, a confirmation of the accomplishment of this inspection is required to be sent to EADS-CASA.
Note: This AD differs from the MCAI and/or service information as follows: (1) Compliance Time: For certain airplanes, the compliance time required by the MCAI or service information for performing the non-destructive inspections is before further flight; however, to avoid inadvertently grounding airplanes, this AD requires performing those inspections within 14 days after the effective date of this AD. (2) Repair: Although the MCAI or service information does not include a repair procedure for cracking, this AD requires the repair of any cracking per the FAA, EASA, or its delegated agent.
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
