Airworthiness Directive · Amendment 39-14817 · Cessna Model 750 Airplanes
Cessna Model 750 Airplanes
Superseded. A later AD replaced this one: AD 2010-20-10. Comply with the one in force.
This AD applies to all Cessna Model 750 airplanes, certificated in any category.
The FAA is adopting a new airworthiness directive (AD) for all Cessna Model 750 airplanes. This AD requires inspecting the inboard- hinge brackets of the left and right elevators for cracking, and doing related investigative and corrective actions if necessary. This AD results from a report of cracking found on the elevator inboard-hinge brackets. We are issuing this AD to detect and correct cracking of the elevator inboard-hinge brackets, which could result in structural failure of the elevators and consequent loss of control of the airplane.
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
After the airplane accumulates 2,500 total flight hours: Perform a general visual inspection for cracking of the inboard-hinge brackets of the left and right elevators in accordance with the Accomplishment Instructions of Cessna Alert Service Letter ASL750-27-21, dated October 13, 2006. Do the inspection before the airplane accumulates 3,000 total flight hours, or within 10 flight hours after the effective date of this AD, whichever is later.
Note 1: For the purposes of this AD, a general visual inspection is: “A visual examination of an interior or exterior area, installation, or assembly to detect obvious damage, failure, or irregularity. This level of inspection is made from within touching distance unless otherwise specified. A mirror may be necessary to enhance visual access to all exposed surfaces in the inspection area. This level of inspection is made under normally available lighting conditions such as daylight, hangar lighting, flashlight, or droplight and may require removal or opening of access panels or doors. Stands, ladders, or platforms may be required to gain proximity to the area being checked.”
If any crack is found during the inspection required by paragraph (f) of this AD: Before further flight, perform an eddy current inspection of the inboard-hinge brackets to determine the crack length, in accordance with the Accomplishment Instructions of Cessna Alert Service Letter ASL750-27-21, dated October 13, 2006; and do the actions specified in paragraph (g)(1) or (g)(2) of this AD, as applicable, at the time specified. All corrective actions must be done using a method approved by the Manager, Wichita Aircraft Certification Office (ACO), FAA. For a replacement method to be approved by the Manager, Wichita ACO, as required by this paragraph, the Manager's approval letter must specifically refer to this AD.
(1) If the crack is 0.30 inch or more: Replace the bracket before further flight.
(2) If the crack is less than 0.30 inch: Continued flight for a maximum of 10 flight hours for repositioning of the airplane and replacement of the bracket is allowed, within the restricted flight envelope included in the attachment to the service letter titled “Flight Restrictions.”
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
Aircraft
