Airworthiness Directive · Amendment 39-14457 · Bombardier Model CL-600-2B19 (Regional Jet Series 100 & 440) Airplanes
Bombardier Model CL-600-2B19 (Regional Jet Series 100 & 440) Airplanes
This AD applies to Bombardier Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes, certificated in any category, serial numbers 7003 through 7986 inclusive.
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. This AD requires replacing the Camloc fasteners on the sidewall of the center pedestal. This AD results from reports of the Camloc fasteners on the sidewall of the center pedestal disengaging and interfering with an inboard rudder pedal. We are issuing this AD to prevent these fasteners from disengaging and interfering with an inboard rudder pedal, which could reduce directional controllability of the airplane.
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
Within 5,500 flight hours after the effective date of this AD, replace, with screws and nut plate assemblies, the Camloc fasteners on the left and right sidewalls of the center pedestal, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 601R-31-030, Revision F, dated September 1, 2005.
Replacing fasteners before the effective date of this AD in accordance with the Accomplishment Instructions of one of the issues of Bombardier Service Bulletin 601R-31-030 identified in Table 1 of this AD is acceptable for compliance with the requirements of paragraph (f) of this AD.
| Issue of Bombardier Service Bulletin 601R-31-030 | Date |
|---|---|
| Original | June 22, 2004. |
| Revision A | October 6, 2004. |
| Revision B | November 4, 2004. |
| Revision C | December 15, 2004. |
| Revision D | June 16, 2005. |
| Revision E | July 7, 2005. |
The aircraft, engines and makers this AD names, by the model designations in its text. A model listed here may still be outside the AD's serial ranges.
