Airworthiness Directive · Amendment 39-11589 · British Aerospace BAe Model ATP Airplanes
British Aerospace BAe Model ATP Airplanes
All Model ATP airplanes, certificated in any category.
Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
This amendment adopts a new airworthiness directive (AD), applicable to all British Aerospace BAe Model ATP airplanes, that requires a one-time detailed visual inspection to detect incorrect installation or discrepancies (damage, bending, overheating, discoloration) of the circuit breaker and the cable terminations of the circuit breaker of the engine de-ice panel. This amendment is prompted by issuance of mandatory continuing airworthiness information by a foreign civil airworthiness authority. The actions specified by this AD are intended to prevent failure of the engine intake de-icing system, which could result in loss of engine intake de-icing capability, accretion of ice in the intake duct, ice ingestion, and consequent engine flameout.
To prevent failure of the engine intake de-icing system, which could result in loss of engine intake de-icing capability, accretion of ice in the intake duct, ice ingestion, and consequent engine flameout, accomplish the following:
(a) Within 3 months after the effective date of this AD: Perform a one-time detailed visual inspection to detect incorrect installation or discrepancies (damage, bending, overheating, discoloration) of the circuit breaker and the cable terminations of the circuit breaker of the engine de-ice panel, in accordance with Part 5 of the Accomplishment Instructions of British Aerospace Service Bulletin ATP-30-52, Revision 1, dated June 12, 1998. If any incorrect installation or discrepancy is detected, prior to further flight, repair it in accordance with the service bulletin.
Note 2: For the purposes of this AD, a detailed visual inspection is defined as: “An intensive visual examination of a specific structural area, system, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at intensity deemed appropriate by the inspector. Inspection aids such as mirror, magnifying lenses, etc., may be used. Surface cleaning and elaborate access procedures may be required.”
