# AD 2026-21-10: Airbus Helicopters

> The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model SA 365 N helicopters. This AD was prompted by reports of tightening torque loss on the input flange nut due to circular wear on the faces of the flange, the slip ring, and the input flange. This condition, if not addressed, could lead to degradation or jamming of the input roller bearings and loss of yaw control of the helicopter. This AD requires repetitive functional inspections (checks) and, depending on the results of the inspections, corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.

Page: https://www.aerscheduler.com/airworthiness-directives/2026-21-10
Maker: Airbus Helicopters
Product: Rotorcraft
Published: October 27, 2026
Effective: November 12, 2026
Amendment: 39-23499
Supersedes: nothing

## At a glance

Quoted from the FAA's summary of this AD. The full text below is what applies.

- What it requires: This AD requires repetitive functional inspections (checks) and, depending on the results of the inspections, corrective actions.
- Applies to: all Airbus Helicopters Model SA 365 N helicopters
- Check an aircraft by N-number: https://www.aerscheduler.com/airworthiness-directives/check

## Applies to

This AD applies to all Airbus Helicopters SA 365 N helicopters, certified in any category.

## What it requires

### Requirements

Except as specified in paragraphs (h) and (i) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2026-0029, dated February 12, 2026 (EASA AD 2026-0029).

### Exceptions

  (1) Where EASA AD 2026-0029 refers to its effective date, this AD requires the effective date of this AD.

  (2) Where EASA AD 2026-0029 requires compliance in terms of flight hours, this AD requires using hours time-in-service.

  (3) Where EASA AD 2026-0029 or the material referenced in EASA AD 2026-0029 specifies “check”, this AD requires replacing that text with “inspection”.

  (4) Where EASA AD 2026-0029 and the material referenced in EASA AD 2026-0029 specify to contact the manufacturer if the comparator gauge confirms a value more than or equal to 0.03 mm, or after completing an oil sample analysis, this AD requires corrective actions in accordance with a method approved by the Manager, International Validation Branch, FAA; EASA; or Airbus Helicopters Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.

### No Reporting Requirement

Although the material referenced in EASA AD 2026-0029 specifies to submit certain information to the manufacturer, this AD does not require that action.

## Source

- The Federal Register document 2026-21854, the legal text: https://www.federalregister.gov/documents/2026/10/27/2026-21854/airworthiness-directives-airbus-helicopters
- Current status and corrections: the FAA's Dynamic Regulatory System, https://drs.faa.gov/

_Not the official record. Whether an AD applies to one aircraft depends on its serial number, installed equipment and records, and is a certificated mechanic's determination._
